Bowflex Xtreme 2 Assembly Manual - Page 7

Step 3: Attach the Lower Lat Tower to the Base Frame Assembly Locate the following items: • From Step 1 - Base Frame Assembly • From Step 2 - Lower Lat Tower Assembly • Item #F - (2) 3/8" X 3/4" Hex Head Bolts • Item #O - (2) 3/8" Washers With the Base Frame Assembly (from Step 1) on the floor, center the Lower Lat Tower Assembly over the Rear Cross Bar (Item #4), as shown in Figure 3. Place the Lower Lat Tower onto the bracket on the Rear Cross Bar. Place (2) 3/8" Washers (Item #O) over the ends of (2) 3/8" X 3/4" Hex Head Bolts (Item #F) - one washer per bolt. Attach the Lower Lat Tower to the Rear Cross Member with the bolts and washers, as shown in Figure 3. Do not tighten hardware from Step 3 at this time. Figure 3 F  Lower Lat Tower Assembly O 4 Base Frame Assembly Step 4: Attach the Seat Support Rail to the Base Frame Assembly Locate the following items: • From Step 3 - Base Frame (Main) Assembly • Item #7 - Seat Support Rail • Item #F - (2) 3/8" X 3/4" Hex Head Bolts • Item #O - (2) 3/8" Washers Insert the Seat Support Rail (Item #7) into the bracket on the Standing Platform (Item #1) and line up the connector at the top of the Seat Support Rail with the bracket on the Lower Lat Tower (Item #5), as shown in Figure 4. Gently push the Seat Support Rail into place in the Lower Lat Tower bracket. Place (2) 3/8" Washers (Item #O) over the end of (2) 3/8" X 3/4" Hex Head Bolts (Item #F) - one washer per bolt. Loosely install the bolts with washers into the two side holes at the top of the Seat Support Rail connector (see Figure 4). Do not tighten hardware from Step 4 at this time. Figure 4 F 7 1 O 5