Brother International FAX-170 Service Manual - Page 143
Error, codes, shown, MACHINE, ERROR, message
![]() |
View all Brother International FAX-170 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
[ 2 ] Error codes shown in the "MACHINE ERROR XX" message Error Code xx (Hex.) 82 87 ( 89 8A ( 8B ( Al ( A2 ( A3 ( A4 A5 A6 A7 A8 A9 AB AC B1 ( B9 ( BA ( BB ( BC ( BD ( BE D1 D2 D3 D4 D5 D6 El ( E4 ( E5 E6 E8 ( EA F3 F5 FF Error factor Recording paper feeding error. Fails to complete the sequence of recording operation. Cutter jam. ) Wrong or weak contact of the recording head connectors. Recording head overheat. ) Recording paper cover opened. ) Document too long to scan. ) Document not detected by the document rear sensor. ) 50% or more faulty of white level data. ) Faulty operation of DMAO during scanning. Faulty operation of DMA1 during scanning. One-line feeding time-out error. One-line scanning time-out error. Abnormal scanning reference voltage. Document feed-in amount measuring error. Less than 50% faulty of white level data. CODEC LSI error. Light emission intensity error of the LED array. ) Scanning error: The left-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected.) Scanning error: The right-hand black reference line which is marked on the document pressure bar for scanning width setting is not detected.) Scanning error: Reduction miss) Scanning error: Enlargement miss) Abnormal clamp BWM value) The MODEM setup bit sticks to High. CTS stays OFF or ON if the MODEM RTS is turned ON or OFF, respectively. Bit Bl A of the MODEM stays OFF. Bit RX of the MODEM stays OFF. The MODEM fails to complete the command transmission sequence. No MODEM interrupt for 60 seconds. Microprocessor (MPU) error on the control panel PCB. Out of recording paper. ) Recording paper set error. ) Write error in E2PROM. Data scanning error during transmission. Document removed at phase B.) Voice message recording or playing-back not started. EOL not found in page memory transmission mode. Interface error of page memory command. Error codes in parentheses do not appear in the "MACHINE ERROR XX", since those errors are displayed as messages described in "[ 1 ] Error messages on the LCD." Those error codes appear in the communications error list if an equipment error occurs during communications. Refer to Section 1.2, (13).
![](/manual_guide/products/brother-international-fax170-service-manual-c38febf/143.png)