Brother International ImageCenter„ ADS2500W Quick Setup Guide - English - Page 22

For Wireless Network Users 10 Manual setup from the control panel using the Setup Wizard (Macintosh, mobile devices and Windows®) You must have the wireless settings you wrote down for your network in step 9-b on page 18 before you proceed. You cannot configure an enterprise wireless network using the Setup Wizard from the control panel. If you choose the SSID for configuring an enterprise wireless network after searching the available SSIDs, the message dialog about Enterprise Authentication Method will appear. To configure an enterprise wireless network, use installer DVD-ROM and follow the instructions. a Press . Swipe up or down, or press a or b to display Network, and then press Network. Swipe up or down, or press a or b to display WLAN, and then press WLAN. Swipe up or down, or press a or b to display Setup Wizard, and then press Setup Wizard. When Enable WLAN? is displayed, press Yes to accept. This will start the wireless setup wizard. To cancel, press No. b The machine will search for available SSIDs. It will take several seconds to display a list of available SSIDs. If a list of SSIDs is displayed, swipe up or down, or press a or b to choose the SSID you wrote down in step 9-b on page 18. Select the SSID you want to connect with, then press OK. If the wireless access point/router of the selected SSID supports WPS and the machine asks to use WPS, go to c. If the machine asks you to enter a Network Key, go to d. Otherwise, go to e. Note • If a list of SSIDs is not displayed, make sure your access point is on. Move your machine closer to the access point and try starting from a again. • If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. For details, see the Network User's Guide. 22 c Press Yes to connect your machine using WPS. (If you choose No (Manual) to continue manual configuration, go to d to enter a Network Key.) When the LCD shows Start WPS, press the WPS button on your wireless access point/router, and then press Next to proceed. Go to e. d Enter the Network Key you wrote down in step 9-b on page 18 using the Touchscreen. Press to cycle between lower case and upper case. Press to cycle between letters, numbers and special characters. (The characters available may differ depending on your country.) To move the cursor to the left or right, press d or c. (For more information, see Entering Text for Wireless Settings on page 35.) Press OK when you have entered all the characters, then press Yes to apply your settings. e Your machine will now try to connect to your wireless network. It may take a few minutes. f A connection result message appears until the OK button is pressed on the LCD. If your wireless device is connected successfully, the LCD shows Connected. If the connection failed, the LCD shows an error code. Make a note of the error code, see Troubleshooting on page 25, and correct the error. Wireless setup is now complete. A four level indicator at the top of your machine's LCD will show the wireless signal strength of your access point/router. To install MFL-Pro Suite, continue to step 11. For Windows® users: Now go to Page 28 For Macintosh users: Now go to Page 31