Brother International Innov-is 1250D Operation Manual - Page 205
The Start/Stop button or Reverse/Reinforcement Stitch button was
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Error Message Probable Cause The "Start/Stop" button or "Reverse/Reinforcement Stitch" button was pressed when no pattern is selected. Bobbin thread has run out. Little bobbin thread remains. When the embroidery unit is attached. You tried to set a number of characters that will not fit within the frame. The upper thread has become tangled around the bobbin case, and the needle is bent and hitting the needle plate, etc., so the sewing machine stops (refer to page 186). You tried a function that cannot be used when the embroidery unit is attached. A card that cannot be used with this product has been inserted, and you tried to select a pattern from the card. 5 An embroidery pattern incompatible with this machine was selected. F01~F07 The utility stitch or character stitch key was pressed while the embroidery unit is attached. You try to retrieve a pattern downloaded as one for a different machine. The machine is in embroidery mode and the combined character pattern is too large for the embroidery frame. You can rotate the pattern 90 degrees and continue combining characters. The "Start/Stop" button, the embroidery key, or the memory key is pressed in embroidery mode, but the embroidery unit is not attached. The bobbin winder is winding the bobbin. If error message "F01" through "F07" appears in the LCD while the sewing machine is being used, the machine may be malfunctioning. Contact your nearest authorized service center. Troubleshooting 203