Brother International Innov-is 1250D Operation Manual - Page 41
Pulling up the bobbin thread
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Pulling up the bobbin thread Pull out about 10 cm (4 inches) of the bobbin e thread under the presser foot toward the rear of the machine. When making gathers or before free-motion quilting, first pull up the bobbin thread as described below. 1 Insert the bobbin into the bobbin case. a • Refer to steps c through g of "Installing the bobbin" (page 29). Pass the bobbin thread through the slot. b Do not cut the thread with the cutter. Reattach the bobbin cover. f Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. While lightly holding the upper thread with c your left hand with the needle in the up- position, press ("Needle Position" button) twice to lower and raise the needle. a "Needle Position" button X The bobbin thread is looped around the upper thread and can be pulled up. Carefully pull the upper thread upward to pull d out the end of the bobbin thread. Upper Threading 39