Brother International Innov-is 1250D Operation Manual - Page 88
Lower the presser foot lever, and then start, sewing., When sewing is finished, cut the thread.,
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
UTILITY STITCHES Lower the presser foot lever, and then start e sewing. • For details, refer to "Starting to sew" (page 53). • For details on sewing reverse/reinforcement stitches, refer to "Securing the stitching" (page 55). When sewing is finished, cut the thread. f • For details, refer to "Cutting the thread" (page 56). ■ Changing the needle position The needle position used as the baseline is different for the straight stitch (left needle position) and the straight stitch (center needle position). 1 2 a Straight stitch (left needle position) b Straight stitch (center needle position) When the stitch width of the straight stitch (left needle position) is set to its standard setting (0.0 mm), the distance from the needle position to the right side of the presser foot is 12 mm (1/2 inch). If the stitch width is changed (between 0 and 7.0 mm (1/4 inch)), the needle position will also change. By changing the stitch width and sewing with the right side of the presser foot aligned with the edge of the fabric, a seam allowance can be sewn with a fixed width. 1 0.0 2.0 5.5 7.0 3 4 5 6 2 a Stitch width setting b Distance from the needle position to the right side of the presser foot c 12.0 mm (1/2 inch) d 10.0 mm (3/8 inch) e 6.5 mm (1/4 inch) f 5.0 mm (3/16 inch) • For details, refer to "Adjusting the stitch width" (page 58). 86