Brother International PT2400 Users Manual - English and Spanish - Page 119
INTERFACE, ERROR, LENGTH, LIMIT, Tab Length, MEMORY, FILES, Error Message, Cause, Solution
UPC - 012502525912
View all Brother International PT2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Error Message INTERFACE ERROR! LENGTH LIMIT! LINE LIMIT! MEMORY FULL! NO FILES! Cause Solution • This message appears if an error occurs while data is being sent from the computer to the P-touch. • Cancel the print job, and then try printing again. • This message appears if you try to print when the baud rates of the computer and the P-touch are not the same. • Cancel the print job, and then select the same baud rate for both the computer and the P-touch. • This message appears if the • Shorten the text to less than text is longer than 3' 3 1/3" (1 3' 3 1/3" (1 meter) before try- meter) when you try to print. ing to print. • This message appears if the Length function is used to set a label length that is less than 1.6 inches (4.0 cm) or more than 11.8 inches (30.0 cm). • Set the label length between 1.6 inches (4.0 cm) and 11.8 inches (30.0 cm). • This message appears if the Tab Length function is used to set a tab length that is more than 11.8 inches (30.0 cm). • Set the tab length so that it is less than 11.8 inches (30.0 cm). • This message appears if the number of lines in the text is greater than the maximum number of lines possible for the installed tape. • Reduce the number of lines or install a tape of greater width. • This message appears if you try to store a text file after 2500 characters have already been stored in the memory. • Delete an unwanted file to make room for the new one. • This message appears if you try to recall or delete a text file from the memory when none are stored. • Store a text file first. 115