Brother International RH-981A Instruction Manual - English - Page 80
Memory switch table, OFF Determined
View all Brother International RH-981A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
10. CHANGING FUNCTIONS USING THE MEMORY SWITCHES 10-1. Memory switch table The memory switch settings are applied immediately to all programs once the settings have been changed. However, memory switches marked with * are only applied after the power is turned on. No. Setting items Setting range Unit Default 00. Cloth presser down operation when feed bracket is OFF, ON forward - OFF 01. Cloth presser stays down after sewing OFF, ON - OFF 02. Number of home position start cycles (Note 1) OFF, 1 - 9 1 1 03. Cutting block ON time 25 - 200 ms 04. Timer for checking raising of hammer OFF (Determined (Timer for determining if the cutting block has been from number of slit raised to a position where it will not touch the next signals), feed bracket to operate) 200 - 500 ms 05. Feed operation timing correction after hammer is 0 - 150 ms raised (After checking that the hammer is raised, the timer interval is added so that the hammer and feed bracket do not touch.) 06. Test feeding deceleration speed OFF, 1 - 4 25 ms 50 ms 25 ms 1 25 ms OFF 0 OFF 07. Increased amount of upper thread remaining OFF, 1 - 3 1 OFF 08. Stitch length display in automatic mode OFF, ON - OFF 09.* Max. stitch length of L7 40 mm, 42 mm 2 mm 40 mm 10. Feed timing correction -10 - 10 1 0 11.* Number of eyelet buttonholes when fly indexer is OFF (Fly indexer is 1 1 used not used),1 - 9 12.* Cloth setting position when fly indexer is used 1: Left setting position 1 1 2: Horizontal setting position 13. Program number selected when buttonhole sensor OFF, 1 - 9 is ON when using the special lapel cutting device 1 OFF 14. Program number for operating the straight OFF, 1 - 9 buttonhole hammer regardless of eyelet shape setting (parameter No. 01) and whether the buttonhole sensor is ON or OFF (Note 2) 1 OFF (Note 1) If home position starting is not carried out for each piece of material, there is the danger that the feed bracket may become overloaded for some reason and come off, which will affect the next piece to be sewn. Accordingly it is recommended that you set home position starting to be carried out each time (setting "1"). (Note 2) If a program number has been set for memory switch No. 13, it will be ignored if a program number has been set for memory switch No. 14. RH-981A 73