Brother International TD-2120N Users Guide - Page 118
Charging the Rechargeable Li-ion Battery
View all Brother International TD-2120N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Chapter 14 Removing the Rechargeable Li-ion Battery 14 Follow the procedure for installing the rechargeable battery to remove the battery cover, and then remove the battery and reattach the cover. CAUTION If it is difficult to remove the rechargeable battery, turning the printer over with the battery cover removed may allow the rechargeable battery to fall out. Be careful that this does not cause any injuries. Charging the Rechargeable Li-ion Battery 14 The rechargeable Li-ion battery can be charged while it is installed in the printer. The battery is recharged when the AC adapter is used while the battery as well as the battery base are attached to the printer. In addition, if the 4 bay battery charger (optional) is used, the battery can be recharged without using the printer. The procedure for charging using the AC adapter is described here. To charge using the 4 bay battery charger (optional), refer to the instruction manual for the optional equipment. NOTE • Up to 5 hours is needed to fully charge a rechargeable Li-ion battery. • You can print about 656.2 ft (200 m) using a new, fully charged battery. (Tested at 73.4 F (23 C) using Brother's print test data (2.25" (57 mm), 9 % coverage) when connected by USB.) • Before using the rechargeable Li-ion battery, use the following procedure to charge it. a Make sure that the rechargeable Li-ion battery and the battery base are installed on the printer. 112