Brother International TD-2120N Users Guide - Page 67
If the STATUS indicator was blinking in red, Customer Service.
View all Brother International TD-2120N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Troubleshooting If the STATUS indicator was blinking in red 7 If the STATUS indicator was blinking in red, perform the following procedures to clear the error. Press the (Power) button once. If the error is still not cleared, turn the printer off, then on again. If the error appears, even after performing the procedures described above, contact Brother Customer Service. Problem The STATUS indicator is blinking. The indicators show that error 1 has occurred. Solution An error occurred. Check the error details in Indicators on page 53, and then see below. Is the correct RD Roll installed? Check that the correct media, for example, type (die-cut label or continuous length tape) and die-cut label size, is installed. Is the RD Roll installed correctly? If not, remove the RD Roll, and then reinstall it. 7 For details, see Inserting the RD Roll on page 15. If the label peeler (optional) is being used, see Inserting the RD Roll on page 106. Are the media guides not touching the side of the RD Roll? Move the media guides against the side of the RD Roll. For details, see Inserting the RD Roll on page 15. Is there enough of the roll remaining? If not, install a new RD Roll. Is the RD Roll compartment top cover open? Check that the RD Roll compartment top cover is closed. After the specified length of time (120 seconds) has passed, either the access point could not be found or two or more access points were found. Otherwise, the received packet is incorrect (when using the optional WLAN interface). 61