Canon EOS 30D EOS 30D Instruction Manual - Page 54

3 Setting the Image-recording Quality Maximum Burst During Continuous Shooting The maximum burst during continuous shooting depends on the image-recording quality and the drive mode (high-speed/low-speed continuous shooting). The approx. maximum burst during continuous shooting is indicated below for each image-recording quality. Note that with high-speed CF cards, the maximum burst may be higher than shown in the table below depending on the shooting conditions. Imagerecording Quality Maximum Burst o High-speed i Low-speed continuous shooting continuous shooting 73 30 37 83 55 100 74 50 60 84 100 165 76 105 240 86 220 850* 1 11 11 1+JPEG 9 9 * Continuous shooting is possible until the CF card becomes full. The number of shots remaining during the maximum burst is displayed on the lower Maximum Burst right of the viewfinder. If "9" is displayed, it indicates that the maximum burst is nine or more shots. If "5" is displayed, it is five shots. While you are shooting and the number of shots remaining in the maximum burst is fewer than 9, the viewfinder will display "8", "7", etc. If you stop the continuous shooting, the maximum burst will increase. After all the captured images are processed and written to the CF card, the above table's figures for the maximum burst will apply. With white balance bracketing (p.68), the maximum burst will be lower. The maximum burst is displayed even when the drive mode is set to (Single) or . The maximum burst is displayed even when a CF card is not in the camera. Therefore, before shooting, make sure that a CF card is installed in the camera. 54