Canon LV-X2 Owners Manual - Page 12

CONNECTING THE PROJECTOR CONNECTING TO A COMPUTER Cables used for connection (✽ = Cable or adapter is not supplied with this projector.) • VGA Cable (HDB 15 pin) • MAC Adapter (When connecting to Macintosh computer) ✽ • Control Cable for PS/2 Port ✽, Serial Port ✽, or ADB Port ✽ • Audio Cable (Mini Plug (stereo) x 1) ✽ • USB Cable ✽ IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) Desktop type Laptop type Monitor Output Audio Output USB port Serial port PS/2 port ADB port MAC Adapter ✽ Set slide switches according to the chart below. Audio Cable ✽ (stereo) USB Cable ✽ VGA Cable USB COMPUTER AUDIO IN Control Cable Control Cable Control Cable for Serial Port ✽ for PS/2 Port ✽ for ADB Port ✽ Terminal Terminal Terminal CONTROL PORT Use one of these Control Cables or USB Cable corresponding with the terminal of your computer only when controlling the computer with the optional Wireless Remote Control Unit. RGB IN VIDEO IN RESET Y -- Pb / Cb -- Pr / Cr COMPUTER AUDIO IN CONTROL AV AUDIO IN S-VIDEO IN AUDIO OUT RGB IN NOTE : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on. N MAC ADAPTER (Not supplied) Set switches as shown in the table ON below depending on RESOLUTION MODE that you want to use before you turn on projector and computer. OFF ON DIP 123456 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF 12 AUDIO OUT Audio Cable (stereo) ✽ Terminals of the Projector Audio Input External Audio Equipment Audio Amplifier Audio Speaker (stereo)