Canon imagePROGRAF iPF850 MFP M40 User Guide - Page 380

Handling and Use of Paper Ejecting to the Stacker iPF850 • Do not move the Stacker by holding at positions other than the specified ones. Moving it by holding at Caution other positions may cause injuries or damage the stacker. • If you move the Stacker too far away from the printer, the Stacker cable may become unplugged from Important the connector. If the stacker cable becomes disconnected, turn off the printer and then connect the Stacker cable to the connector and turn the printer back on again. Ejecting to the Stacker • When ejecting to the Stacker, do not print using the following settings. These can cause paper jams. Important • Borderless printing • Trim Edge First is On(Input Length), On (Preset Len), or Automatic • TrimEdge Reload is On or Automatic • Do not use the Stacker for printing that takes a long time, such as banner printing. This can cause paper jams, because the rollers that feed the paper stop rotating after a fixed time after paper is detected in the Stacker. • For information on paper that is supported for ejecting to the Stacker, refer to the Paper Reference Guide. (See Note "Displaying the Paper Reference Guide.") ➔P.335 The operation may not function correctly for paper not listed here. • The Stacker can hold 100 sheets of A0 size. (When the AutoCAD LT2004 sample image Cottage Plan and Eleva- tion.dwg was printed) 1 Install the Stacker on the printer. (See "Installing and Removing the Stacker On the Printer.") ➔P.376 2 Start printing on roll paper. • Do not put your hand, etc. in the paper ejection path during printing. This may cause injuries or damage Caution the stacker. • Do not open the Canopy during printing. Important 3 Open the Canopy and remove the printed documents after the printing has finished. Stacker • Do not put your hand into the base part of the Canopy or the paper feed path when you open or close the 380 Caution Canopy. Your hand may get caught, causing injuries or damaging the Stacker. User's Guide