Cisco 3825 Software Configuration Guide - Page 157

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference gsm-abis congestion enable gsm-abis congestion enable The congestion detection algorithm monitors the transmit jitter buffer and sends congestion indicator signals to the remote when congestion is detected. The remote will suppress all timeslots that are not defined as critical in an effort to alleviate the congestion. The goal of the congestion detection algorithm is to save the critical timeslots from loss of data. To enable the congestion detection algorithm, use the gsm-abis congestion enable Interface configuration command. gsm-abis congestion enable Syntax Description This command has no arguments or keywords. Defaults There are no default settings or behaviors. Command Modes Interface configuration Command History Release 12.4(2)MR Modification This command was introduced. Examples The following example shows how to enable the gsm-abis congestion: Router(config)# interface Serial10/1/0:0 Router(config-if)# no ip address Router(config-if)# encapsulation gsm-abis Router(config-if)# load-interval 30 Router(config-if)# gsm-abis local 10.10.10.2 6661 Router(config-if)# gsm-abis remote 10.10.10.1 5553 Router(config-if)# gsm-abis congestion enable Router(config-if)# no keepalive Related Commands Command gsm-abis congestion abate gsm-abis congestion critical gsm-abis congestion onset gsm-abis jitter Description Sets the congestion abatement detection level at which the remote router will stop suppressing timeslots because congestion has been alleviated. Defines the critical timeslots that are exempt from suppression during congestion onset. Sets the congestion onset detection level at which the remote router will start suppressing all timeslots that are not defined as critical in an effort to alleviate the congestion. Sets the amount of transmit jitter delay for the GSM-Abis interface. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-25