Cisco 3825 Software Configuration Guide - Page 62

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line Clocking Requirements for Cisco 3825 Router Clock Source Command The clock source command configures the source for synchronization of the interface transmit clock. Configure clock source line if the router is deriving its clock externally from the connected device. Configure clock source internal if the router provides the master clock (for example, either the internal clock or the network clock). The show network-clocks command allows verification of the clocking configuration. mwr2#sh network-clocks Network Clock Configuration Priority Clock Source Clock State Clock Type 1 E1 0/0/0 GOOD E1 10 Backplane GOOD PLL Current Primary Clock Source Priority Clock Source Clock State Clock Type 1 E1 0/0/0 GOOD E1 The previous output of show network-clocks corresponds to the following configuration (see Figure 4-2 for description of how the clocking is done): no network-clock-participate slot 1 network-clock-participate wic 0 network-clock-participate wic 1 network-clock-participate wic 2 no network-clock-participate aim 0 no network-clock-participate aim 1 network-clock-select 1 E1 0/0/0 controller E1 0/0/0 clock source line channel-group 0 timeslots 1-31 speed 64 Figure 4-2 Clocking Example Clocking BSC---z___MWR_A---z___MWR_B---z____BTS 0/1/0 0/0/0 0/0/0 0/1/0 92854 1. The BSC provides clock synchronization to the MWR_A router. 2. The MWR_A router receives clock from the BSC via port 0/1/0 and distributes to port 0/0/0. 3. The MWR_B router receives clock from the MWR_A router via port 0/0/0 and distributes to port 0/1/0. 4. The Base Transceiver STATION (BTS) receives clock synchronization from the MWR_B router. 5. The clock synchronization from the BSC is propagated through the network to the BTS. Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide 4-4 OL-15667-03