Cisco 3825 Software Configuration Guide - Page 199
pw-pvc
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference pw-pvc pw-pvc To configure permanent virtual circuit (PVC) mapping or rewrite the PW configured for a PVC, use the pw-pvc command. This command specifies the PW-side vpi/vci value to be used inside PW packet payload in sending and receiving PW packets for a specified PVC. pw-pvc [pw-vpi]/[pw-vci] Syntax Description pw-vpi pw-vci Pseudowire-side vpi value Pseudowire-side vci value Defaults By default, PW-side vpi/vci value is the same as the attachment circuit-side vpi/vci value. Command Modes l2transport VC mode Command History Release 12.4(2)MR2 Modification This command was introduced. Examples The following example illustrates the use of the pw-pvc command. Router# config t Router(config-if)# pvc 0/40 l2transport Router(config-if-atm-l2trans-pvc)# encapsulation aal0 Router(config-if-atm-l2trans-pvc)# pw-pvc 1/40 Router(config-if-atm-l2trans-pvc)# xconnect 1.1.1.1 40 encapsulation mpls Router(config-if-atm-l2trans-pvc-xconn)# exit Router(config-if-atm-l2trans-pvc)# exit Router(config-if)# exit Router(config)# exit Related Commands Command xconnect Description The xconnect command is used to bind an attachment circuit to a PW in one of the supported configuration modes. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-67