Cisco 3825 Software Configuration Guide - Page 268

xconnect logging redundancy Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference xconnect logging redundancy To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the xconnect logging redundancy command in global configuration mode. To disable syslog reporting of the status of the xconnect redundancy group, use the no form of this command. xconnect logging redundancy no xconnect logging redundancy Syntax Description This command has no arguments or keywords. Defaults Syslog reporting of the status of the xconnect redundancy group is disabled. Command Modes Global configuration Command History Release 12.0(31)S 12.2(28)SB 12.4(11)T 12.4(16)MR Modification This command was introduced. This command was integrated into Cisco IOS Release 12.2(28)SB. This command was integrated into Cisco IOS Release 12.4(11)T. This command was integrated into Cisco IOS Release 12.4(16)MR. Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group. Examples The following example enables syslog reporting of the status of the xconnect redundancy group and shows the messages that are generated during switchover events: Router# config t Router(config)# xconnect logging redundancy Router(config)# exit Activating the Primary Member 00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000 Activating the Backup Member: 00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001 Related Commands Command xconnect Description Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit to an L2TPv3 PW for xconnect service and enters xconnect configuration mode. A-136 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03