Cisco 4948-10GE Installation Guide - Page 83
Performing the Initial Configuration
UPC - 746320958668
View all Cisco 4948-10GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Appendix B Initial Configuration for the Switch Entering the Initial Configuration Information Performing the Initial Configuration Follow these steps to complete the initial configuration for the switch: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 At the terminal prompt, enter the enable command to enter privileged exec mode: Switch> enable Password: password Switch# Set the system time using the clock set command in privileged EXEC mode. Switch# clock set 20:09:01 3 Apr 2006 Verify the change by entering the show clock command. Switch# show clock 20:09:06.079 UTC Thu Apr 3 2006 Enter the configure terminal command to enter global configuration mode. Switch# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Switch (config)# Configure a host name for the switch, and press Return. Switch (config)# hostname Switch1 Configure the system prompt for the switch, and press Return. To remove the new prompt and return the prompt to its default, use the no prompt command. Switch (config)# prompt Switch1> Step 7 Step 8 Use the banner motd global configuration command to set location information in the login banner. You can also set a system contact using this command. Switch1(config)# banner motd c 170 West Tasman Drive, San Jose, CA c or Switch1 (config)# banner motd c 170 West Tasman Drive, San Jose, CA; Tech Support 408 123 4567 c Configure an enable secret password, and press Return. 78-18039-02 Catalyst 4900 Series Switch Installation Guide B-5