Cisco WS-C3560V2-24TS-E Command Reference - Page 594
spanning-tree bpdufilter, spanning-tree portfast bpdufilter default
View all Cisco WS-C3560V2-24TS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 594 highlights
spanning-tree bpdufilter Chapter 2 Catalyst 3560 Switch Cisco IOS Commands spanning-tree bpdufilter Use the spanning-tree bpdufilter interface configuration command to prevent an interface from sending or receiving bridge protocol data units (BPDUs). Use the no form of this command to return to the default setting. spanning-tree bpdufilter {disable | enable} no spanning-tree bpdufilter Syntax Description disable enable Disable BPDU filtering on the specified interface. Enable BPDU filtering on the specified interface. Defaults BPDU filtering is disabled. Command Modes Interface configuration Command History Release 12.1(19)EA1 Modification This command was introduced. Usage Guidelines You can enable the BPDU filtering feature when the switch is operating in the per-VLAN spanning-tree plus (PVST+), rapid-PVST+, or the multiple spanning-tree (MST) mode. Caution Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in spanning-tree loops. You can globally enable BPDU filtering on all Port Fast-enabled interfaces by using the spanning-tree portfast bpdufilter default global configuration command. You can use the spanning-tree bpdufilter interface configuration command to override the setting of the spanning-tree portfast bpdufilter default global configuration command. Examples This example shows how to enable the BPDU filtering feature on a port: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# spanning-tree bpdufilter enable You can verify your setting by entering the show running-config privileged EXEC command. 2-562 Catalyst 3560 Switch Command Reference 78-16405-05