Cisco WVC210 Administration Guide - Page 43

Configuring the Cisco WVC210 Internet Camera Software Setup > Basic Settings 8 • Time Zone-Choose the time zone for your location from the drop-down list. • Adjust for Daylight Saving Time-Select this option if your location is currently using Daylight Saving Time. You must uncheck the Adjust for Daylight Saving Time check box manually when Daylight Saving Time ends in your time zone. • Check here if you want to update the time automatically through the NTP Server on the Internet-Enable or disable the time server feature as required. If enabled, the camera will contact a network time server at regular intervals and update its internal timer. • NTP Server Address-Enter the address of the NTP Server. NOTE If connecting to a router, it may be necessary to enable port forwarding. See "Configuring Port Forwarding" on page 67. Network Settings Configuration Type • Obtain An IP Address Automatically-The camera defaults to this option, allowing a DHCP server on your network to automatically assign the camera an IP address. • Fixed IP Address-Use this option to assign a fixed (static) IP address to the camera. Assign an IP address that is unique to your local network. When using a fixed IP address, you must configure the IP Address, Subnet Mask, Gateway, and DNS. • IP Address-The IP address assigned to the camera. • Subnet Mask-The Subnet Mask assigned to the camera. • Gateway-IP address of the gateway router between this device and management stations that exist on other network segments. • Primary DNS-The IP address of your ISP's primary server, which translates the names of websites into IP addresses. • Secondary DNS-The IP address of your ISP's secondary server, which translates the names of websites into IP addresses. WVC210 Wireless-G PTZ Internet Video Camera With 2-Way Audio Administration Guide 37