D-Link DGS-1100-08V2 User Manual 1.00 WW - Page 19
System > System Information Settings > IPv4 Interface, System > Port configuration > Port Settings
View all D-Link DGS-1100-08V2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4 Configuration D-Link Smart Managed Switch User Manual System Location Specify the system location of the Switch. System Contact Specify the system contact of the Switch. Web Session Timeout (60-36000) The Web Session Timeout controls the idle time-out period for security purposes, when there is no activity in the web interface within the specified time-out period. If the current session times out (expires), the user is required to log into the web management interface again. Selective range is from 60 to 36000 seconds, and the default setting is 180 seconds. Table 4.1 Click Apply to make the configurations take effect. System > System Information Settings > IPv4 Interface The IPv4 Interface allows the user to configure the IP address and the basic system information of the Switch. Figure 4.14 - System > System Information Settings > IPv4 Interface The fields that can be configured for IP Settings are described below: Item Description IP Settings There are two ways for the Switch to obtain an IP address: Static and DHCP (Dynamic Host Configuration Protocol). When using static mode, the IP Address, Mask, Gateway and DHCP Retry Time can be manually configured. When using DHCP mode, the Switch will first look for a DHCP server to provide it with an IP address (including network mask and default gateway) before using the default or previously entered settings. IP Address Specify the IPv4 address. By default, the IP address is 10.90.90.90 Mask Specify the subnet mask of IP address. By default, the subnet mask is 255.0.0.0 Gateway Specify the gateway of IP address. By default, the gateway is 0.0.0.0 DHCP Retry Time (5120) Specify the number of attempts to assign an IP address through a DHCP server. Selective range is from 5 to 120 times, and the default setting is 7 times. Table 4.2 Click Apply to make the configurations take effect. System > Port configuration > Port Settings In the Port Setting page, the status of all ports can be monitored and configured. 16