D-Link DGS-1100-08V2 User Manual 1.00 WW - Page 20
System > Port Configuration > Jumbo Frame, System > PoE > PoE System (DGS-1100-05PDV2/08PV2 only)
View all D-Link DGS-1100-08V2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
4 Configuration D-Link Smart Managed Switch User Manual Figure 4.15 - System > Port Configuration > Port Settings The fields that can be configured for Port Settings are described below: Item Description From Port / To Port Select a range of ports to be configured. State Enable or disable the specified ports. Speed Copper connections can operate in Forced Mode settings 1000 Mbps (full-duplex), 100 Mbps (full/half-duplex), 10 Mbps (full/half-duplex), Auto, or Disabled. The default setting for all ports is Auto. Flow control You can enable this function to mitigate traffic congestion. Ports configured for full-duplex use 802.3x flow control, halfduplex ports use backpressure flow control. The default setting is Disabled. Description Specify a description for the chosen ports Capability Advertised When the Speed is set to Auto, these capabilities are advertised during auto-negotiation. Table 4.3 Click Apply to make the configurations take effect. Click Refresh button to update the port status information. NOTE: Be sure to adjust port speed settings appropriately after changing the connected cable media types. System > Port Configuration > Jumbo Frame D-Link Smart Managed Switches support jumbo frames (frames larger than the Ethernet frame size of 1536 bytes) of up to 9216 bytes (tagged). This function is disabled by default. Select Enabled then click Apply to turn on the jumbo frame support. Figure 4.16 - System > Port Configuration > Jumbo Frame System > PoE > PoE System (DGS-1100-05PDV2/08PV2 only) The PoE System page will display the PoE status including System Budget Power, Support Total Power, Remainder Power, and the ratio of system power supply. 17