D-Link DGS-1100-24P Reference Guide - Page 57
From Port / To Port, Loopback Detection Global Settings
![]() |
View all D-Link DGS-1100-24P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
D-Link DGS-1100 Series Switch User Manual The fields that can be configured for Loopback Detection Global Settings are described below: Parameter Loopback Detection Time Interval Recover Time Loopback Detection Trap Description Select to enable or disable loopback detection. The default is Disabled. Set a Loop detection Interval between 1 and 32767 seconds. The default is 10 seconds. Time allowed (in seconds) for recovery when a Loopback is detected. The Loop Detection Recover Time can be set at 0 seconds, or 60 to 1000000 seconds. Entering 0 will disable the Loop Detection Recover Time. The default is 60 seconds. Select to enable or disable the loopback detection trap state. Click the Apply button to accept the changes made. The fields that can be configured for Loopback Detection Port Settings are described below: Parameter From Port / To Port State Description Select the appropriate port range used for the configuration here. Select this option to enable or disable the state of the port. Click the Apply button to accept the changes made. Note: If Spanning Tree protocol is used, loopback detection will not be available. If Loopback Detection is enabled, the Spanning Tree protocol will not be available. 51
![](/manual_guide/products/dlink-dgs110024p-reference-guide-47bed4b/57.png)