Dell Alienware 15 R3 Service Manual - Page 43
Replacing the computer base, Procedure, Post-requisites
View all Dell Alienware 15 R3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Replacing the computer base WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Procedure 1 Align the screw holes on the computer base with the screw holes on the palmrest assembly. 2 Replace the 11 screws (M2.5x8) that secure the computer base to the palmrest assembly. 3 Replace the two screws (M2x3) that secure the computer base to the palmrest assembly. 4 Connect the tron-light cables to the system board. 5 Route the marco-keys cable, keyboard cable, and keyboard-backlight cable through the routing guides on the computer base. 6 Slide the macro-keys cable, keyboard cable, and keyboard-backlight cable into their respective connectors on system board and close the latches to secure the cables. 7 Route the antenna cables through the routing guides on the computer base. Post-requisites 1 Replace the rear-I/O cover. 2 Replace the wireless card. 3 Replace the solid-state drive. 4 Follow the procedure from step 4 to step 6 in "Replacing the hard drive". 5 Replace the base cover. 43