Dell CX4 Troubleshooting Guide - Page 12
Supported Cluster Configurations, Direct-Attached Cluster - cables
View all Dell CX4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Supported Cluster Configurations The following sections describe the supported cluster configurations. Direct-Attached Cluster In a direct-attached cluster, all the nodes of the cluster are directly attached to a single storage system. In this configuration, the RAID controllers (or storage processors) on the storage system are connected by cables directly to the Fibre Channel HBA ports in the nodes. Figure 1-1 shows a basic direct-attached, single-cluster configuration. Figure 1-1. Direct-Attached, Single-Cluster Configuration cluster node public network private network cluster node Fibre Channel connections storage system Fibre Channel connections EMC PowerPath Limitations in a Direct-Attached Cluster EMC PowerPath® provides failover capabilities, multiple path detection, and dynamic load balancing between multiple ports on the same storage processor. However, the direct-attached clusters supported by Dell connect to a single port on each storage processor in the storage system. Because of the single port limitation, PowerPath can provide only failover protection, not load balancing, in a direct-attached configuration. 12 Introduction