Dell Force10 C300 C300 Hardware Installation Guide - Page 47
To remove and replace a C300 RPM, Depress the thumb tabs, Extend the levers
View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
To remove and replace a C300 RPM: Step 1 2 Task Unplug any network interface cables connected to the RPM. Extend the left and right card levers by first pressing gently down on the thumb tabs (see Figure 10-4) in the ejector levers and then pulling the ejector levers simultaneously until they are in the open position. See Figure 10-5. Figure 10-4. Depress the thumb tabs Figure 10-5. Extend the levers 3 Pull the card by the card levers until it is out of the slot. Avoid touching the printed circuit board and connector pins. 4 If you are not replacing the RPM, insert an RPM blank panel. 5 If you are replacing the RPM, follow the instructions in Installing the RPMs and Line Cards on page 18. 6 Only after the replacement is installed, power up the chassis. Removing and Replacing Components | 47