Dell Force10 C300 C300 Hardware Installation Guide - Page 63

Component Power Requirements Table B-5. Component Power Requirements Component 48-port 1G Line Card 4-port 10G XFP Line Card 8-port 10G XFP Line Card 48-port 1G SFP Line Card 48-port 1G PoE Line Card 46-port FlexMedia Line Card 46-port FlexMedia PoE Line Card C300 RPM Fan Tray AC Power Supply Unit DC Power Entry Module Catalog Number LC-CB-GE-48T LC-CB-10GE-4P LC-CB-10GE-8P LC-CB-1GE-48P LC-CB-GE-48V LC-CB-10G-1G-36T LC-CB-10G-1G-36V LC-CB-RPM CC-C300-FAN CC-C-1200W-AC CC-C-PWR-DC Maximum Watts 150W 150W 200W 130 150W 120W 120W 165W 90W 1200W 1400W NOTE: The listed requirement for the PoE version of line cards excludes the required power for PoE, as that requirement is a function of the number and type of PoE devices connected. NOTE: Additional components may be available for your system, other than those included in the above table. Refer to www.force10networks.com for the latest information. Agency Compliance The C300 system is designed to comply with the following requirements. USA Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own expense. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Force10 is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. System Specifications | 63