Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1030

www.dell.com | support.dell.com mib-binding c e s Enable this OSPF process ID to manage the SNMP traps and process SNMP queries. Syntax mib-binding To mib-binding on this OSPF process, enter no mib-binding. Defaults None. Command Modes ROUTER OSPF Command History Version 7.8.1.0 Introduced to all platforms. Usage This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the Information first OSPF process will be used. If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility. network area c e s Define which interfaces run OSPF and the OSPF area for those interfaces. Syntax network ip-address mask area area-id To disable an OSPF area, use the no network ip-address mask area area-id command. Parameters ip-address mask area-id Specify a primary or secondary address in dotted decimal format. The primary address is required before adding the secondary address. Enter a network mask in /prefix format. (/x) Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal value range: 0 to 65535 IP address format: dotted decimal format A.B.C.D. Note: If the area ID is smaller than 65535, it will be converted to a decimal value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1. Command Modes ROUTER OSPF Command History Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced support for Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage To enable OSPF on an interface, the network area command must include, in its range of addresses, Information the primary IP address of an interface. Note: An interface can be attached only to a single OSPF area. 1030 | Open Shortest Path First (OSPFv2 and OSPFv3)