Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1283

privilege level (CONFIGURATION mode) c e s Change the access or privilege level of one or more commands. Syntax privilege mode {level level | reset} To delete access to a level and command, use the no privilege mode level level command. Parameters mode level level reset command Enter one of the following keywords as the mode for which you are controlling access: • configure for the CONFIGURATION mode • exec for the EXEC mode • interface for the INTERFACE modes • line for the LINE mode • route-map for the ROUTE-MAP • router for the ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP modes. Enter the keyword level followed by a number for the access level. Range: 0 to 15. Level 1 is the EXEC mode and Level 15 allows access to all CLI modes and commands. Enter the keyword reset to return the security level to the default setting. Enter the command's keywords to assign the command to a certain access level. You can enter one or all of the keywords Defaults Not configured. Command Modes CONFIGURATION Command History Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced for S-Series Introduced for C-Series Introduced for E-Series Usage Use the enable password command to define a password for the level to which you are assigning Information privilege or access. privilege level (LINE mode) c e s Change the access level for users on the terminal lines. Syntax privilege level level To delete access to a terminal line, use the no privilege level level command. Parameters level level Enter the keyword level followed by a number for the access level. Range: 0 to 15. Level 1 is the EXEC mode and Level 15 allows access to all CLI modes. Defaults level = 15 Command Modes LINE Security | 1283