Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 30

www.dell.com | support.dell.com Related Commands show bootvar Display the variable settings for the E-Series boot parameters. boot network c e Set the location of the configuration file in a remote network. Syntax boot network {primary | secondary} remote-url Parameters primary secondary remote-url Enter the keywords primary to attempt to load the primary network configuration files. Enter the keywords secondary to attempt to load the secondary network configuration files. Enter the following location keywords and information: • For a file on an FTP server, enter ftp://user:password@hostip/filepath • For a file on a TFTP server, enter tftp://hostip/filepath Defaults None Command Modes CONFIGURATION Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage To display these changes in the show bootvar command output, you must save the running Information configuration to the startup configuration (using the copy command). Related Commands show bootvar Display the variable settings for the E-Series boot parameters. boot system c e Tell the system where to access the FTOS image used to boot the system. Syntax boot system {rpm0 | rpm1} (default | primary | secondary} file-url Parameters rpm0 rpm1 default primary Enter the keyword rpm0 to configure boot parameters for RPM0. Enter the keyword rpm1 to configure boot parameters for RPM1. After entering rpm0 or rpm1, enter the keyword default to specify the parameters to be used if those specified by primary or secondary fail. The default location should always be the internal flash device (flash:), so that you can be sure that a verified image is available there. After entering rpm0 or rpm1, enter the keyword primary to configure the boot parameters used in the first attempt to boot FTOS. 30 | File Management