Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1361

Defaults No default values or behavior Command Modes CONFIGURATION Command History Version 7.6.1.0 Version 7.5.1.0 Support added for S-Series Support added for C-Series E-Series legacy command snmp-server enable traps c e s Enable and configure SNMP traps. Syntax snmp-server enable traps [notification-type] [notification-option] To disable traps, use the no snmp-server enable traps [notification-type] [notification-option] command. Parameters notification-type notification-option Enter the type of notification from the list below: • bgp-Notification of changes in BGP process • envmon-For Dell Force10, device notifications when an environmental threshold is exceeded • snmp-Notification of RFC 1157 traps. • stp -Notification of state change in Spanning Tree protocol (RFC 1493) • vrrp-Notification of state change in a VRRP group • xstp-Notification of state change in MSTP (802.1s), RSTP (802.1w), and PVST+ For the envmon notification-type, enter one of the following optional parameters: • fan • supply • temperature For the snmp notification-type, enter one of the following optional parameters: • authentication • coldstart • linkdown • linkup Defaults Not enabled. Command Modes CONFIGURATION Command History Version 8.4.2.5 Version 8.4.1.3 Version 8.4.1.0 Version 7.6.1.0 New format for VRRP traps was introduced on the C-Series. New STP, RSTP, and PVST+ traps for root and topology changes were added on the C-Series. New format for VRRP traps was introduced on the E-Series ExaScale. New STP, RSTP, and PVST+ traps for root and topology changes were added on the E-Series ExaScale. Support was added for VRRP traps. Support added for S-Series; Added support for STP and xSTP traps. SNMP and Syslog | 1361