Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 614

www.dell.com | support.dell.com speed (Management interface) c e Set the speed for the Management interface. Syntax speed {10 | 100 | auto} To return to the default setting, use the no speed {10 | 100} command. Parameters 10 100 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Enter the keyword 100 to set the interface's speed to 100 Mb/s. Enter the keyword auto to set the interface to auto-negotiate its speed. Defaults auto Command Modes INTERFACE Command History Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced on C-Series Introduced for E-Series Usage This command is found on the Management interface only. Information Related Commands interface ManagementEthernet duplex (Management) management route Configure the Management port on the system (either the Primary or Standby RPM). Set the mode of the Management interface. Configure a static route that points to the Management interface or a forwarding router. switchport c e s Place an interface in Layer 2 mode. Syntax switchport [backup interface {gigabit slot/port | tengigabit slot/port | port-channel number}] To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter no switchport. If a switchport backup interface is configured, you must first remove the backup configuration. To remove a switchport backup interface, enter no switchport backup interface {gigabit slot/port | tengigabit slot/port | port-channel number}]. Parameters backup interface gigabit tengigabit port-channel slot/port Use this option to configure a redundant Layer 2 link without using Spanning Tree. This keyword configures a backup port so that if the primary port fails the backup port changes to the up state. If the primary later comes up, it becomes the backup. Enter this keyword if the backup port is a 1G port. Enter this keyword if the backup port is a 10G port. Enter this keyword if the backup port is a static or dynamic port channel. Specify the line card and port number of the backup port. 614 | Interfaces