Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1414

www.dell.com | support.dell.com Command Modes INTERFACE (conf-if-interface-slot/port) Command History Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Version 6.5.1.0 Introduced on S-Series Introduced on C-Series E-Series Only: Added percentage decimal value option Introduced on E-Series storm-control multicast (Configuration) c s Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series networks only. Syntax storm-control multicast packets_per_second in To disable storm-control for multicast traffic into the network, use the no storm-control multicast packets_per_second in command. Parameters packets_per_second in C-Series and S-Series Only: Enter the packets per second of multicast traffic allowed into the network followed by the keyword in. Range: 0 to 33554431 Defaults No default behavior or values Command Modes CONFIGURATION (conf) Command History Version 7.6.1.0 Introduced on C-Series and S-Series only Usage Information Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when storm control thresholds are exceeded. storm-control multicast (Interface) c s Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only. Syntax storm-control multicast packets_per_second in To disable multicast storm control on the interface, use the no storm-control multicast packets_per_second in command. Parameters packets_per_second in C-Series and S-Series Only: Enter the packets per second of broadcast traffic allowed into the network. Range: 0 to 33554431 Defaults No default behavior or values Command Modes INTERFACE (conf-if-interface-slot/port) 1414 | Storm Control