Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 96

www.dell.com | support.dell.com Parameter vrf host ip-address ipv6-address count datagram size timeout source tos df-bit validate-reply (OPTIONAL) E-Series Only: Enter the VRF Instance name of the device to which you are testing connectivity. (OPTIONAL) Enter the host name of the devices to which you are testing connectivity. (OPTIONAL) Enter the IPv4 address of the device to which you are testing connectivity. The address must be in the dotted decimal format. (OPTIONAL) E-Series only Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity. Note: The :: notation specifies successive hexadecimal fields of zeros Enter the number of echo packets to be sent. number: 1- 2147483647 Continuous: transmit echo request continuously Default: 5 Enter the ICMP datagram size. Range: 36 - 15360 bytes Default: 100 Enter the interval to wait for an echo reply before timing out. Range: 0 -3600 seconds Default: 2 seconds Enter the IPv4 or IPv6 source ip address or the source interface. For IPv6 addresses, you may enter global addresses only. • Enter the IP address in A.B.C.D format • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • E-Series only For the SONET interfaces, enter the keyword sonet followed by slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. (IPv4 only) Enter the type of service required. Range: 0-255 Default: 0 (IPv4 only) Enter Y or N for the "don't fragment" bit in IPv4 header N: Do not set the "don't fragment" bit Y: Do set "don't fragment" bit Default is No. (IPv4 only) Enter Y or N for reply validation. N: Do not validate reply data Y: Do validate reply data Default is No. 96 | Control and Monitoring