Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 979

ipv6 nd max-ra-interval e Configure the interval between the IPv6 router advertisement (RA) transmissions on an interface. Syntax ipv6 nd max-ra-interval {interval} min-ra-interval {interval} To restore the default interval, use the no ipv6 nd max-ra-interval command. Parameters max-ra-interval {interval} min-ra-interval {interval} Enter the keyword max-ra-interval followed by the interval in seconds. Range: 4 to 1800 seconds Enter the keyword min-ra-interval followed by the interval in seconds. Range: 3 to 1350 seconds Defaults Max RA interval: 600 seconds, Min RA interval: 200 seconds Command Modes INTERFACE ipv6 nd mtu c e s Configure an IPv6 neighbor discovery. Syntax ipv6 nd mtu number Parameters mtu number Set the MTU advertisement value in Routing Prefix Advertisement packets. Range: 1280 to 9234 Defaults No default values or behavior Command Modes INTERFACE Command History Usage Information Version 8.3.1.0 Introduced The ip nd mtu command sets the value advertised to routers. It does not set the actual MTU rate. For example, if ip nd mtu is set to 1280, the interface will still pass 1500-byte packets. The mtu command sets the actual frame size passed, and can be larger than the advertised MTU. If the mtu setting is larger than the ip nd mtu, an error message is sent, but the configuration is accepted. Related Commands % Error: nd ra mtu is greater than link mtu, link mtu will be used. mtu Set the maximum link MTU (frame size) for an Ethernet interface. Neighbor Discovery Protocol (NDP) | 979