Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 751

Command Modes Command History multicast soft in out EXEC Privilege Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 (OPTIONAL) Enter the keyword multicast to select the multicast option within the selected address family. Multicast is supported on IPv4 only (OPTIONAL) Enter the keyword soft to configure and activate policies without resetting the BGP TCP session, that is, BGP Soft Reconfiguration. Note: If you enter clear ip bgp ip6-address soft, both inbound and outbound policies are reset. (OPTIONAL) Enter the keyword in to activate only inbound policies. (OPTIONAL) Enter the keyword out to activate only outbound policies. Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale clear ip bgp peer-group c e Reset a peer-group's BGP sessions. Syntax clear ip bgp peer-group peer-group-name Parameters peer-group-name Enter the peer group name to reset the BGP sessions within that peer group. Command Modes EXEC Privilege Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale clear ip bgp ipv6 dampening c e Clear information on route dampening and return suppressed route to active state. Syntax clear ip bgp ipv6 unicast dampening [ipv6-address] Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 The :: notation specifies successive hexadecimal fields of zeros Command Modes EXEC Privilege Command History Version 8.4.2.1 Introduced on C-Series and S4810. IPv6 Border Gateway Protocol (IPv6 BGP) | 751