Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 669

linecard slot-number configuration (OPTIONAL) Enter the keyword linecard followed by the number of the line card slot. C-Series Range: 0-7 E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a E300 Note: This keyword is not available on the S-Series. (OPTIONAL) Enter the keyword configuration to display the physical interfaces with non-default configurations only. Command Modes EXEC EXEC Privilege Command History Version 8.1.1.2 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Supported on E-Series ExaScale E600i Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Example Figure 24-16. show ip interface Command Example FTOS#show ip int te 0/0 TenGigabitEthernet 0/0 is down, line protocol is down Internet address is not set IP MTU is 1500 bytes Inbound access list is not set Proxy ARP is enabled Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent FTOS# Table 24-12. show ip interface Command Example Items Lines TenGigabitEthernet 0/0... Internet address... IP MTU is... Inbound access... Proxy ARP... Split horizon... Poison Reverse... ICMP redirects... ICMP unreachables... Description Displays the interface's type, slot/port and physical and line protocol status. States whether an IP address is assigned to the interface. If one is, that address is displayed. Displays IP MTU value. Displays the name of the any configured incoming access list. If none is configured, the phrase "not set" is displayed. States whether proxy ARP is enabled on the interface. States whether split horizon for RIP is enabled on the interface. States whether poison for RIP is enabled on the interface States if ICMP redirects are sent. States if ICMP unreachable messages are sent. IPv4 Routing | 669