Dell Inspiron 16 Plus 7630 Owners Manual- NVIDIA GeForce RTX 4060 - Page 59
Installing the display assembly, Steps
View all Dell Inspiron 16 Plus 7630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Steps 1. Remove the two screws (M2.5x5.5) that secure the left display-assembly hinge to the system board. 2. Pry open the left display-assembly hinge at an angle of 90 degrees. 3. Peel the tape that secures the display-cable latch to its connector. 4. Pry open the latch and disconnect the display-assembly cable from its connector on the system board. 5. Remove the two screws (M2.5x5.5) that secure the right display-assembly hinge to the system board. 6. Open the right display-assembly hinge at an angle of 90 degrees. 7. At an angle, gently lift the palm-rest and keyboard assembly off the display assembly. Installing the display assembly CAUTION: The information in this section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure. Removing and installing Field Replaceable Units (FRUs) 59