Dell Latitude 5404 Dell Latitude 14 Rugged 5404Series Owners Manual - Page 15

Installing the Docking Board, Removing the GPU Board, Bottom Cover, Battery

Get Dell Latitude 5404 PDF manuals and user guides View all Dell Latitude 5404 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

b. Unroute the antenna cables [2]. c. Remove the screws that secure the docking board [3]. d. Flip the docking board [4]. e. Lift the release tab [5]. f. Disconnect the docking board connector cable from the system board [6]. 4. Lift and remove the docking board from the computer chassis. Installing the Docking Board 1. Connect the docking board connector cable to the system board. 2. Flip the docking board and seat it on the slot. 3. Tighten the screws to secure the docking board. 4. Route the antenna cables. 5. Connect the antenna cables to the docking board. 6. Install: a. Bottom Cover b. Battery 7. Follow the procedures in After Working Inside Your computer Removing the GPU Board 1. Follow the procedures in Before Working Inside Your Computer 2. Remove: a. Battery b. Hard Drive c. Optical Drive d. Bottom Cover e. Docking Board 3. Perform the following steps as shown in the illustration: a. Remove the screws that secure the GPU socket to the computer [1]. b. Lift GPU socket from the board [2]. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
b.
Unroute the antenna cables [2].
c.
Remove the screws that secure the docking board [3].
d.
Flip the docking board [4].
e.
Lift the release tab [5].
f.
Disconnect the docking board connector cable from the system board [6].
4.
Lift and remove the docking board from the computer chassis.
Installing the Docking Board
1.
Connect the docking board connector cable to the system board.
2.
Flip the docking board and seat it on the slot.
3.
Tighten the screws to secure the docking board.
4.
Route the antenna cables.
5.
Connect the antenna cables to the docking board.
6.
Install:
a.
Bottom Cover
b.
Battery
7.
Follow the procedures in
After Working Inside Your computer
Removing the GPU Board
1.
Follow the procedures in
Before Working Inside Your Computer
2.
Remove:
a.
Battery
b.
Hard Drive
c.
Optical Drive
d.
Bottom Cover
e.
Docking Board
3.
Perform the following steps as shown in the illustration:
a.
Remove the screws that secure the GPU socket to the computer [1].
b.
Lift GPU socket from the board [2].
15