Dell Latitude 5404 Dell Latitude 14 Rugged 5404Series Owners Manual - Page 33
Installing the Battery Connector, Removing the System Board
View all Dell Latitude 5404 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Installing the Battery Connector 1. Place the battery connector on the system board.. 2. Tighten the screws that secure the battery connector to the computer. 3. Connect the battery connector cable. 4. Install: a. I/O Board b. Bottom Cover c. Optical Drive d. Hard Drive e. Battery 5. Follow the procedures in After Working Inside Your computer Removing the System Board 1. Follow the procedures in Before Working Inside Your Computer 2. Remove: a. Battery b. Hard Drive c. Optical Drive d. Bottom Cover e. GPS Holder f. WLAN Card g. WWAN Card h. 3. Perform the following steps as shown in the illustration: a. Lift the locking tab [1]. b. Disconnect the mother board connector cable [2]. 33
Installing the Battery Connector
1.
Place the battery connector on the system board..
2.
Tighten the screws that secure the battery connector to the computer.
3.
Connect the battery connector cable.
4.
Install:
a.
I/O Board
b.
Bottom Cover
c.
Optical Drive
d.
Hard Drive
e.
Battery
5.
Follow the procedures in
After Working Inside Your computer
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
2.
Remove:
a.
Battery
b.
Hard Drive
c.
Optical Drive
d.
Bottom Cover
e.
GPS Holder
f.
WLAN Card
g.
WWAN Card
h.
3.
Perform the following steps as shown in the illustration:
a.
Lift the locking tab [1].
b.
Disconnect the mother board connector cable [2].
33