Dell OptiPlex 3046 Small Form Factor Owners Manual - Page 15
Installing the heat sink assembly, Removing the processor
![]() |
View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
b Loosen the captive screws that secure the heat sink assembly and lift it away from the computer [2] [3]. Installing the heat sink assembly 1 Place the heat sink assembly onto the processor. 2 Tighten the captive screws to secure the heat sink assembly to the system board. 3 Connect the heat sink cable to the system board. 4 Install the: a fan duct b optical drive c hard drive assembly d front bezel e cover 5 Follow the procedure in After Working Inside Your Computer. Removing the processor 1 Follow the procedure in Before Working Inside Your Computer. 2 Remove the: a cover b front bezel c hard drive assembly d optical drive e fan duct f heat sink 3 To remove the processor: a Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1]. b Lift the lever upward and lift the processor shield [2]. c Lift the processor out of the socket [3]. Removing and installing components 15
![](/manual_guide/products/dell-optiplex-3046-small-form-factor-owners-manual-b0e1caa/15.png)