Dell OptiPlex 3046 Small Form Factor Owners Manual - Page 20
Installing the SD card reader, Removing the system board
View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
b Remove the screws that secure the SD card reader and lift it away from the computer [2] [3]. Installing the SD card reader 1 Place the SD card reader on the chassis. 2 Tighten the screws that secure the SD card reader to the computer. 3 Route the power supply unit cables into the retention clips. 4 Install the: a power supply unit b optical drive c hard drive assembly d front bezel e cover 5 Follow the procedure in After Working Inside Your Computer. Removing the system board 1 Follow the procedure in Before Working Inside Your Computer. 2 Remove the: a cover b fan duct c front bezel d memory module e hard drive assembly f optical drive g expansion card h SD card reader i VGA daughter board j heat sink k processor 3 To remove the I/O panel: a Remove the screw that secures the I/O panel to the chassis [1]. b Remove the I/O panel from the computer [2]. Removing and installing components 20