Dell OptiPlex 3046 Small Form Factor Owners Manual - Page 28

System error messages

Get Dell OptiPlex 3046 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Error messages Description X:\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY Insert a disk into the drive and try again. System error messages Table 3. System error messages System message Description Alert! Previous attempts at booting this system The computer failed to complete the boot routine three have failed at checkpoint [nnnn]. For help in consecutive times for the same error. resolving this problem, please note this checkpoint and contact Dell Technical Support CMOS checksum error RTC is reset, BIOS Setup default has been loaded. CPU fan failure CPU fan has failed. System fan failure System fan has failed. Hard-disk drive failure Possible hard disk drive failure during POST. Keyboard failure Keyboard failure or loose cable. If reseating the cable does not solve the problem, replace the keyboard. No boot device available No bootable partition on hard disk drive, the hard disk drive cable is loose, or no bootable device exists. • If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a boot device. • Enter system setup and ensure that the boot sequence information is correct. No timer tick interrupt NOTICE - Hard Drive SELF MONITORING SYSTEM has reported that a parameter has exceeded its normal operating range. Dell recommends that you back up your data regularly. A parameter out of range may or may not indicate a potential hard drive problem A chip on the system board might be malfunctioning or motherboard failure. S.M.A.R.T error, possible hard disk drive failure. Troubleshooting your computer 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
Error messages
Description
X:\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY
Insert a disk into the drive and try again.
System error messages
Table 3. System error messages
System message
Description
Alert! Previous attempts at booting this system
have failed at checkpoint [nnnn]. For help in
resolving this problem, please note this
checkpoint and contact Dell Technical Support
The computer failed to complete the boot routine three
consecutive times for the same error.
CMOS checksum error
RTC is reset,
BIOS Setup
default has been loaded.
CPU fan failure
CPU fan has failed.
System fan failure
System fan has failed.
Hard-disk drive failure
Possible hard disk drive failure during POST.
Keyboard failure
Keyboard failure or loose cable. If reseating the cable does
not solve the problem, replace the keyboard.
No boot device available
No bootable partition on hard disk drive, the hard disk drive
cable is loose, or no bootable device exists.
•
If the hard drive is your boot device, ensure that the cables
are connected and that the drive is installed properly and
partitioned as a boot device.
•
Enter system setup and ensure that the boot sequence
information is correct.
No timer tick interrupt
A chip on the system board might be malfunctioning or
motherboard failure.
NOTICE - Hard Drive SELF MONITORING SYSTEM has
reported that a parameter has exceeded its
normal operating range. Dell recommends that
you back up your data regularly. A parameter
out of range may or may not indicate a
potential hard drive problem
S.M.A.R.T error, possible hard disk drive failure.
Troubleshooting your computer
28