Dell PowerConnect FCS624S Release Notes - Page 12

FastIron(config-if-e1000-3/1)# no ip address 10.10.10.10/24 Syntax: no ip address 2. Assign a new IP address to the interface. For example, enter a command such as the following. FastIron(config-if-e1000-3/1)# ip address 10.10.2.1/24 Syntax: ip address 3. To save the configuration, enter the write memory command on the CLI as displayed in the following example. FastIron(config)# write memory FastIron(config)# end 4. Reload the FSX Base L3 device by entering the following command: FastIron# reload The DHCP-client service feature is now removed from the interface. To enable DHCP-client service on an interface on a FSX Base L3 device when a static IP address is assigned to the interface, enter the following commands. 1. Remove the static IP address assigned to the interface. For example, enter a command such as the following. FastIron(config-if-e1000-3/1)# no ip address 10.10.10.10/24 Syntax: no ip address 2. To save the configuration, enter the write memory command on the CLI as displayed in the following example. FastIron(config)# write memory FastIron(config)# end 3. Reload the FSX Base L3 device by entering the following command: FastIron# reload Once the device has reloaded, the DHCP-client service will start up and a new dynamic IP address is assigned to the interface. The DHCP-client service feature is now enabled on the interface. Note regarding Telnet and Internet Explorer 7 The Telnet function in Web management does not work with Internet Explorer version 7.0.5730. The system goes to "telnet://10.43.43.145" page when the user clicks web/general system configuration/ (telnet) in Internet Explorer version 7.0.5730. This is a known issue for Internet Explorer. To work around this issue, you must download and install a patch for IE 7. To do so, go to http://www.lib.ttu.edu.tw/file/IE7_telnet.reg. IronWare Software Release 07.2.00a for Brocade FastIron switches Release Notes v 1.0 Page 12 of 55