Dell PowerConnect M6220 Configuration Guide - Page 95
MAC ACL CLI Examples, Example #3: Apply the Rule to Outbound Egress Traffic on Port 1/g2
View all Dell PowerConnect M6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Example #3: Apply the Rule to Outbound (Egress) Traffic on Port 1/g2 Only traffic matching the criteria will be accepted. console(config)#interface ethernet 1/g2 console(config-if-1/g2)#ip access-group list1 out console(config-if-1/g2)#exit MAC ACL CLI Examples The following are examples of the commands used for the MAC ACLs feature. Example #4: Set up a MAC Access List console#config console(config)#mac access-list extended mac1 console(config)#exit Example #5: Specify MAC ACL Attributes console(config-mac-access-list)#deny ? any Configure a match condition for all the source MAC addresses in the Source MAC Address field. Enter a MAC Address. console(config-mac-access-list)#deny any ? any bpdu Configure a match condition for all the destination MAC addresses in the Destination MAC Address field. Match on any BPDU destination MAC Address. Enter a MAC Address. console(config-mac-access-list)#deny any 00:11:22:33:44:55 ? Enter a MAC Address bit mask. console(config-mac-access-list)#deny any 00:11:22:33:44:55 00:00:00:00:FF:FF ? assign-queue cos log mirror redirect vlan Configure the Queue Id assignment attribute. Configure a match condition based on a COS value. Configure logging for this access list rule. Configure the packet mirroring attribute. Configure the packet redirection attribute. Configure a match condition based on a VLAN ID. Enter a four-digit hexadecimal number in the range of 0x0600 to 0xffff to specify a custom Ethertype value. Press enter to execute the command. Enter one of the following keywords to specify an Ethertype (appletalk, arp, ibmsna, ipv4, ipv6, ipx, Device Security 95