Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1176

OS10(config-sec-profile)# certificate dv-fedgov-s6010-1 OS10(config-sec-profile)# revocation-check OS10(config-sec-profile)# peer-name-check OS10(config-sec-profile)# exit OS10(config)# OS10(config)# radius-server host radius-server-2.test.com tls security-profile radiusprof key radsec OS10(config)# end OS10# show running-configuration crypto security-profile ! crypto security-profile radius-prof certificate dv-fedgov-s6010-1 OS10# show running-configuration radius-server radius-server host radius-server-2.test.com tls security-profile radius-prof key 9 2b9799adc767c0efe8987a694969b1384c541414ba18a44cd9b25fc00ff180e9 Cluster security When you enable VLT or a fabric automation application, switches that participate in the cluster use secure channels to communicate with each other. The secure channels are enabled only when you enable the VLT or fabric cluster configuration on a switch. OS10 installs a default X.509v3 certificate-key pair to establish secure channels between the peer devices in a cluster. NOTE: From 10.5.1.0 release onwards, there is no need for X.509v3 certificate in a VLT domain if both the VLT peers are running OS10 software version 10.5.1.0 or later. However, you still need the certificates during VLT upgrade from earlier version to 10.5.1.0. The upgraded VLT device has to communicate with the other VLT peer in a domain until the other device is also upgraded to 10.5.1.0. Replace the default certificate-key pair used for cluster applications: ● In a deployment where untrusted devices access management or data ports on an OS10 switch. ● Before the default X.509v3 certificate expires on July 27, 2021. If the default certificate-key pair expires, the VLT domain on peer switches does not come up. NOTE: The expiration date for the default certificate-key pair that is installed by OS10 on a switch running the 10.5.0.0 release is July 27, 2021. To ensure secure communication in a cluster before the expiration date, install a more recent X.509v3 certificate-key pair. Create a custom X.509v3 certificate-key pair by configuring an application-specific security profile using the cluster security-profile command. Before the default or custom X.509v3 certificate-key pair that is used between the peer devices in a VLT domain or fabric application cluster expires, install a valid CA certificate by following the procedures in: ● Manage CA certificates. ● Request and install host certificates. When you replace the default certificate-key pair for cluster applications, ensure that all devices in the cluster use the same custom certificate-key pair or a unique certificate-key pair that is issued by the same CA. CAUTION: While you replace the default certificate-key pair, cluster devices temporarily lose their secure channel connectivity. Dell EMC Networking recommends that you change the cluster security configuration during a maintenance time. This example shows how to install an X.509v3 CA and host certificate-key pair for a cluster application. For more information, see: ● Importing and installing a CA certificate - see Manage CA certificates. ● Generating a CSR and installing a host certificate - see Request and install host certificates. 1. Install a trusted CA certificate. OS10# copy tftp://CAadmin:[email protected]/GeoTrust_Universal_CA.crt home:// GeoTrust_Universal_CA.crt OS10# crypto ca-cert install home://GeoTrust_Universal_CA.crt Processing certificate ... Installed Root CA certificate 1176 Security