Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 987

Example (IPv4) OS10(config-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# allowas-in 5 Example (IPv6) OS10(conf-router-template)# address-family ipv6 unicast OS10(conf-router-bgp-template-af)# allowas-in 5 Example (l2vpn) OS10(config-router-neighbor)# address-family l2vpn evpn OS10(config-router-bgp-neighbor-af)# allowas-in 3 Supported Releases 10.3.0E or later sender-side-loop-detection Enables the sender-side loop detection process for a BGP neighbor. Syntax Parameters Default Command Mode Usage Information Example (IPv4) sender-side-loop-detection None Enabled ROUTER-BGP-NEIGHBOR-AF This command helps detect routing loops, based on the AS path before it starts advertising routes. To configure a neighbor to accept routes use the neighbor allowas-in command. The no version of this command disables sender-side loop detection for that neighbor. OS10(conf-router-bgp-102)# neighbor 3.3.3.1 OS10(conf-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# sender-side-loop-detection Example (IPv6) OS10(conf-router-bgp-102)# neighbor 32::1 OS10(conf-router-neighbor)# address-family ipv6 unicast OS10(conf-router-bgp-neighbor-af)# no sender-side-loop-detection Supported Releases 10.3.0E or later show ip bgp l2vpn evpn Displays the internal BGP routes in the L2VPN EVPN address family in EVPN instances. Syntax Parameters show ip bgp l2vpn evpn [summary | neighbors [ip-address | interface interface-type]] summary neighbors ip-address interface interfacetype Displays a summary of the BGP routes in the L2VPN address family that exchange with remote VTEPs. Display the remote VTEPs with whom BGP routes in the L2VPN address family exchange. Displays information about a specific neighbor. Displays BGP information that is learned through an unnumbered neighbor. Default Not configured Command mode EXEC VXLAN 987