Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1200

Example Supported Releases OS10(config-if-port-sec)# mac-move allow 10.5.1.0 or later mac-move violation Configures station move violation actions. Syntax Parameters mac-move violation {drop | log | shutdown-both | shutdown-offending | shutdown-original} ● drop - Drops the received packet when an interface detects the same MAC address that the system has already learned on a different interface. ● log - Displays a log message when an interface detects the same MAC address that the system has already learned on a different interface. ● shutdown-both - Shuts down both interfaces that learned the same MAC address. ● shutdown-offending - Shuts down the interface which detects the same MAC address that the system has already learned on a different interface. ● shutdown-original - Shuts down the interface that originally learned the MAC address. Default Command Mode The system displays a log message when a MAC address move violation occurs. CONFIGURATION-PORT-SECURITY Usage Information Example The no version of this command disables MAC move violation actions. OS10(config-if-port-sec)# mac-move-violation log If you configure the system with the mac-move-violation log command, the system displays a log message similar to the following: MAC Move Violation occurred: originalInterface: ethernet 1/13/1, offendingInterface: Ethernet 1/13/2,vlanId: 100, MACAddr: 00:00:07:00:04:15. Supported Releases 10.5.1.0 or later mac address-table static Configures a static entry for the Layer 2 MAC address table. Syntax Parameters mac address-table static mac-address vlan vlan-id interface {ethernet node/ slot/port[:subport] | port-channel number} ● mac-address - Enter the MAC address to add to the table in nn:nn:nn:nn:nn:nn format. ● vlan vlan-id - Enter the VLAN to apply the static MAC address to, from 1 to 4093. ● interface - Enter the interface type: ○ ethernet node/slot/port[:subport] - Enter the Ethernet information. ○ port-channel channel-number - Enter a port-channel interface number, from 1 to 128. Default Command Mode Usage Information Not configured CONFIGURATION If you configure the switchport port-security command on an interface, you can configure MAC address learning limit, sticky MAC address, and control MAC move. The no version of this command resets the value to the default. 1200 Security