Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 175

Delay request messages transmitted Delay request messages received Delay response messages transmitted Delay response messages received Management messages transmitted Management messages received Signaling messages transmitted Signaling messages received Interface : Ethernet1/1/23 Total number of peers : 1 Peer index : 0 Peer Clock Identity Peer Port number Peer Port Address Receiving Interface Announce messages transmitted Announce messages received Sync messages transmitted Sync messages received Follow up messages transmitted Follow up messages received Delay request messages transmitted Delay request messages received Delay response messages transmitted Delay response messages received Management messages transmitted Management messages received Signaling messages transmitted Signaling messages received : 74292 : 0 : 0 : 74286 : 0 : 0 : 0 : 0 : 00:17:00:ff:fe:00:02:00 : 1 : 23.0.0.2 : ethernet1/1/23 : 41207 : 0 : 2637200 : 0 : 0 : 0 : 0 : 2389638 : 2389638 : 0 : 0 : 0 : 0 : 0 View the PTP state and lock status OS10# show ptp servo Servo State Lock Status : Locked : Phase-locked Example: Configure boundary clock with L2 transport method You must connect the grandmaster clock to one of the interfaces. In this example, interface 1 is connected to the grandmaster clock. Configure a boundary clock with two PTP interfaces using L2 transport method. The interface that is connected to the grandmaster clock or the best master clock becomes the slave device. The other interface becomes the master clock. 1. Configure the PTP boundary clock. The delay mechanism of the boundary clock is end-to-end by default. OS10(config)# ptp clock boundary 2. Enable PTP on interface 1 with L2 multicast transport mode. PTP role is dynamic by default. OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ptp transport layer2 OS10(conf-if-eth1/1/1)# ptp enable 3. Enable PTP on interface 2 with L2 multicast transport mode. PTP role is dynamic by default. OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# ptp transport layer2 OS10(conf-if-eth1/1/2)# ptp enable Interface 1 becomes the slave device and interface 2 becomes the master clock device for other devices. System management 175