Dell PowerSwitch S4128F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 507

View detect and recovery details OS10# show errdisable detect Error-Disable Cause Detect Status bpduguard Enabled OS10# show errdisable recovery Error-Disable Recovery Timer Interval: 300 seconds Error-Disable Reason Recovery Status bpduguard Enabled Recovery Time left Interface Errdisable Cause (seconds) ethernet 1/1/1:1 bpduguard 273 ethernet 1/1/2 bpduguard 4 port-channel 12 bpduguard 45 MAC flush optimization OS10 offers a MAC address clearing technique that optimizes the number of MAC flush calls sent by the Spanning Tree Protocol (STP) module. If the number of calls sent to the hardware is too high, traffic is dropped or flooded impacting system performance. To prevent traffic drops and flooding, you can use the MAC flush optimization feature. This feature fine-tunes the MAC flush-related parameters, such as the MAC flush threshold and the MAC flush timer to reduce the number of calls sent to the hardware. The clear request sent to clear the MAC address table entry is called a flush indication. The number of calls that are sent is displayed as flush invocations in the show spanning-tree command. You can enable the MAC flush optimization feature by setting the MAC flush timer to a non-zero value. This feature is enabled by default with a default timer value of 200 centi-seconds. To disable MAC flush optimization, configure the MAC flush timer value to 0. When you configure the MAC flush timer to a non-zero value and the threshold to zero, the system invokes instance-based flush once and starts the timer. When the timer expires, the system invokes an instance-based flush again. The show spanning-tree {brief | details | active} command displays the following information: Flush Interval 200 centi-sec, Flush Invocations 32 Flush Indication threshold 2 By default, this feature is enabled for RSTP, Rapid-PVST and MSTP. This feature is useful in a scalable topology with MSTP & rapid-PVST (multi-instance), where multiple MAC flush calls are invoked. RSTP RSTP allows per port-based flush until the number of calls sent is equal to the MAC flush threshold value that you have configured. When the number of calls that are sent reaches the configured threshold, RSTP ignores further per-port based flush and starts the MAC flush timer. When the timer expires, RSTP invokes an entire table flush, where it requests one flush for all the ports. RSTP is a single instance and hence, MAC flush optimization is not required. However, to enable this feature, configure the MAC flush timer to a non-zero value. This configuration is applied globally and applies for RSTP, MSTP, and rapid-PVST. This configuration is retained when you change the STP mode. For RSTP, the threshold is set to a higher value (65,535) because RSTP does not require this optimization. Even when this feature is enabled, the global flush is invoked only after the flush count reaches 65,535. MSTP MSTP allows (VLAN-list, port) based flush until the number of calls sent is equal to the MAC flush threshold value that you have configured. Layer 2 507